-
Anonymous users2024-01-241. All the general 6140 tailstock is mold No. 5, you can not fix the flat drill sleeve must be the tailstock mold sleeve wear or need to clamp the drill sleeve wear, in one reason the need to clamp the drill sleeve is defective, the mold is not standard. If it's all new and not worn, wipe the oil off the top.
-
Anonymous users2024-01-23Swap the sleeve or polish the contents.
-
Anonymous users2024-01-22Yes. Match it yourself.
-
Anonymous users2024-01-21You see if the tail is flat and worn out.
Hello! Lathe tailstock.
Lathe tailstock >>>More
The manual feed of the tailstock is changed to a motor plus reducer drive, and the motor drives the reducer to transmit the power to the top feed screw through the clutch to achieve feed. When an automatic feed is not required, the clutch is disconnected and the operator can turn the lead screw by the handwheel to achieve the center feed.
Generally, there is a handle on the outside of the tailstock of the lathe, which can be self-locking by pulling it tightly.
The Mohs taper sleeve of the tailstock drill sleeve of each lathe is not necessarily the same, there are Mohs 3, Mohs 2, Mohs 4, 5, and 6. CW6163 or above lathe metric and so on. I can't say for sure how big, the lathe model configuration is not fixed on the Mohs scale or metric cone, to seek truth from facts can not be misleading, I hope to adopt thank you.
The tailstock of ordinary lathes can not move automatically, and it needs to be drilled automatically or can be modified to give it power, so there is a tailstock changing automatic feed punching device, which is sold on the market, and it can not be advertised on the Internet. The effect is good, there is a video you can watch.