In the panel furniture industry, how to prevent ebony veneer blistering?

What is the solids content of the glue you use? Is the amount of glue applied evenly and appropriately? Pressure and temperature? How long does it take to press? Does the glue contain sufficient resistance to solvents? Moisture content of wood? It's up to you to find out.

The results are different for different processes, and there is no such problem in the "paint first and then wrap" process of Conch Company.

When sticking the veneer, there is more water in the glue, and when it dries, the wood absorbs the water, and it blisters. If it is pasted at a high temperature, you can use an iron that can be used to make soup clothes and heat the soup on its surface for 5 to 10 seconds.

Good maintenance is the most critical, do not put it in a place exposed to the sun, do not put it in a place that is easy to be exposed to rain, and reasonably place the product in a ventilated position indoors, so that the ebony can achieve the maximum service life.

The second is to wax maintenance, the newly bought slab should be waxed every three months before the first two years, which is very necessary, not only to make the board clean and shiny, but also to protect the paint film and delay aging.

Ebony furniture advantages:

1. Wood is shiny, no special smell, corrosion resistance, strong wear resistance, hard and heavy material, delicate, and is a very rare precious furniture and handicraft materials.

2. The black wood is sandwiched with gray-brown to light red light-colored stripes, wear-resistant and non-deformed after drying, with high oiliness, and obvious oiling phenomenon after high temperature.

3. It is slightly transparent after fine polishing and is not easy to crack.

4. The texture is straight; The structure is fine and uniform.

5. Very heavy; Extremely high intensity.

6. The dry shrinkage rate is small. The cut surface is smooth and delicate.

Ebony furniture cons:

1. Weak luster; Wet wood has a sour taste; Slightly oily.

2. Planing and sawing are difficult to process, and it is easy to blunt sawing.

3. Slow drying and easy to crack.