-
Anonymous users2024-01-24The key is to find the incoming cable from the distribution box to the kitchen and water heater. It used to be two roads, but now it can only be separated from the meter!
-
Anonymous users2024-01-23The mechanical watt-hour meter can be used normally.
According to the current power of the kitchen and electric water heater, the main line is 4 square, and the socket is square.
The pressure of the tap water in your house is not enough, and the water is no pressure when the floor is high, and there is a water flow pressure detection switch in the water heater. If the pressure is too low or the water flow is too small, it will automatically shut down the liquefied gas. This is a safety switch to prevent the water heater from drying out.
If you want to control each other, just connect the hot water pipes. But I advise you not to connect, two water heaters gas water heaters for the vegetable basin hot water, electric water heater bath, so that you can save water and electricity, do not pre-drain a lot of cold water,.
Clogged lines or fittings!
Inspect the sprinkler head (remove the sprinkler head to see the amount of water coming out of its interface, and if it is sufficient, clean or replace the sprinkler head); >>>More
Natural gas water heaters cannot be installed in restrooms. Because the gas water heater needs to consume a lot of oxygen during use, and the bathroom is a closed space, if the lack of oxygen in the bathroom is caused, a large amount of carbon monoxide, carbon dioxide and other toxic gases will be produced, which is easy to cause hypoxia and fainting accidents during the bathing process.