-
Anonymous users2024-01-24Clogged lines or fittings!
Inspect the sprinkler head (remove the sprinkler head to see the amount of water coming out of its interface, and if it is sufficient, clean or replace the sprinkler head);
The second is to check the pipe joints connected to the mixing valve;
If there is no problem in the above two places, you can only disassemble and check the pipeline along the interface section by section. Generally, if the pipeline is a PPR hot melt pipe, it is very likely that the interface adhesive melt was not cleaned during the installation and welding of the pipeline; If the pipeline is an aluminum-plastic pipe or a steel pipe, it is possible that the raw material belt of the interface has not been cleaned up.
-
Anonymous users2024-01-23What about water pressure? How long has it been used? Is there limescale clogging the water pipes? Why don't you call here to ask questions when this kind of problem arises?
-
Anonymous users2024-01-22It's very simple, look at the inlet of your water heater, and whether the faucet is a little blocked, just clean it up, the main blockage is scale, raw material belt, pipe rust can do it yourself, you won't find a plumber, O( O haha
-
Anonymous users2024-01-21The pipeline is too long and the pressure is not enough, so it is recommended not to change the water heater, and it is natural to use less pipes. So once and for all".
It is related to water pressure, it is easy to start far away, the plastic film inside the gas water heater is broken, I used to use the Chigo water heater every other year, this phenomenon will appear, I have to call someone to change it once, it costs dozens of yuan, and the cost is less than a dime. . . Caused by high water temperature.
Gas or electric water heaters can be used to access the kitchen and bathroom.
If you want to control each other, just connect the hot water pipes. But I advise you not to connect, two water heaters gas water heaters for the vegetable basin hot water, electric water heater bath, so that you can save water and electricity, do not pre-drain a lot of cold water,.
This should be the water heater inlet and outlet pipes in the filter screen is blocked, close the water inlet valve, open the valve to the water heater connection pipe (including the pressure reducing safety valve), find the filter screen to clean it, and then install it back in place, you can not operate it, you can find the property department or other maintenance personnel to operate.
The cold water is normal, the hot water output is small, you should consider why the original hot water is large, and now the hot water is small, the reason is that the scale deposit is more and the problem of clogging the pipeline. >>>More