-
Anonymous users2024-01-24Your handling is improper, just enter the water should not be shut down, directly remove the battery. Then wipe the surface clean, blow it dry with cold air, and let it stand for a few days until the water in the motherboard evaporates before turning it on for use, or blow dry it and take it to after-sales service for processing.
Water ingress of the mobile phone is not considered to be covered by the warranty, that is, you will be charged for after-sales service now. You can take it to the after-sales service for a test, and then repair it or not, or you can go to a small store to repair it. Some after-sales tests are charged, and some are free.
-
Anonymous users2024-01-23Do you dare to take it to after-sales?
...I'm convinced. You need to remove the battery immediately after the phone gets into the water. It cannot be turned on or off. If you turn it on without blow drying, it's going to break. It will cause the motherboard to burn off. Take it for repairs.
If the phone falls into the water, don't continue to use it, turn off the phone first, take out the battery, wrap it in paper, and then wrap the phone in paper, put it in the rice bucket together, and then take it out and use it after 5 or 7 days, the problem should not be big, at least there will be no problem with your current problem! Now your problem, I guess it should be the moisture inside the mobile phone attached to the front camera, so the front camera can't respond! It is recommended that you send it for repair!
Your mobile phone must have been flooded, you shouldn't use a hair dryer to blow it, the way at that time was to remove the mobile phone battery and put it in the quilt with the mobile phone, and I turned it on after a night.
Did you get into the water? It is useless to dry the surface when you enter, and remember to dry it with warm air next time. This motherboard of yours should be broken.
You don't need to repair it first, you disassemble the battery first, if it is non-removable, turn it off, wrap it in newspaper and put it in the refrigerator for a few hours, then take it out and let it dry before trying to turn it on. If there is still a problem, there is no way, just fix it.