-
Anonymous users2024-01-24First of all, you have to remove the bulb from the bath bomb;
Then buckle the panel, the panel is the kind of plate integrated into the ceiling, the edge is buckled on the auxiliary keel, with a slotted screwdriver along one side of the plug, a pry down.
Some of the lamp base parts inside are stuck on the auxiliary keel with clips, so you have to remove the gusset around the bath bomb, and then remove the fastener to remove the lamp.
It should be noted that before disassembly, be sure to cut off the power supply and pay attention to safety.
It can be hooked with 4 No. 8 wires, and there is a small hole in each corner.
There are only two possibilities for dry tripping, short circuit or overload. You turn off all the switches on the lights and see if you can send them on. Generally speaking, the probability of a problem with the line is very small, try to change the middle bulb.
One is connected to the bath bomb heating switch 1, one is connected to the bath bomb heating switch 2, one is connected to the bath bomb fan switch, and the other is connected to the power supply live wire, and the power supply live line is connected to 3 bath bomb switches at the same time to supply the live wire power supply. Finally, the zero line of the bath bomb is directly connected to the zero line of the ceiling. To sum up, 4 wires are used for the 1 in 3 out of the live wire to control the 3 electrical appliances of the bath bomb.
PVC ceiling bath bomb, generally the outside cover is alive - you can buckle it down directly, and you will see that there is a self-tapping wire fixed inside. The bath bomb can be removed by removing the self-tapping wire.
The terminal utility inside the bath bomb is burned out. Remove the bath bomb from the ceiling and rewire.