-
Anonymous users2024-01-24It may be because there is a problem with the water storage plug in the toilet, and the pressure of the water after flushing cannot make it close well, and the pressure of the water needs to be pressed tightly after the water tank is full, so it is stopped.
-
Anonymous users2024-01-23The part of the toilet that automatically reloads the water is broken and cannot be automatically stopped. You can remove it and go to the hardware store to buy a replacement for the water ingress. If you are interested in "how to stop the water", you can disassemble it to clean and check, usually the tie rod is too long (or broken), the waterproof seal is broken, the water pipe is stuck with foreign objects, etc.
If your toilet is new, you can directly find the merchant to replace it unconditionally, if the toilet has been used for a long time, it should be the sanitary ware in the tank that is damaged, buy new sanitary ware to find the professional staff of the merchant to replace it, and the sanitary ware plus the replacement labor cost is less than 100 yuan.
Yes, after the float is raised, the sealing gasket is not tight, or it may be misaligned, adjust the position.
Cause of water leakage:
1. The internal parts of the water tank are aging; >>>More
1. You can take off the lid on the toilet tank and put the water outlet direction of a white plastic inlet pipe towards the water tank wall, which will reduce the sound when approaching the water. >>>More
The main thing to see is that the water valve is not closed tightly, or there is a problem with the plug, or the internal mechanical parts are faulty, and only after inspection can you know how to repair, and the water supply valve is not closed tightly to replace it with a new one.