-
Anonymous users2024-01-24Cement you can directly add water to stick the tiles, the problem lies in the letter of your interface agent, the interface agent in some places in China is Duanling glue, not the interface agent. The glue deteriorates at high temperatures, turning black and smelly. The addition of formaldehyde can prolong the deterioration period of the combustion wheel.
Liduomeixing interface agent, cement.
-
Anonymous users2024-01-23The problem lies in your interface agent, and the interface agent in some places in China is glue, not the interface agent. The glue deteriorates at high temperatures, turning black and smelly. The addition of formaldehyde can prolong the deterioration period.
Liduomeixing interface agent, cement.
Of course, no, the interface agent is mainly suitable for the pretreatment of the base interface of concrete, aerated concrete, small blocks, lightweight partition walls, brick-concrete walls, putty scraping, tile bonding, masonry back coating and thermal insulation boards. Therefore, it is a material for treating the base surface, not a waterproofing material. Bathroom waterproofing, of course, it is recommended to use special waterproof materials, you can use special kitchen and bathroom waterproof slurry, first use quick-setting repair mortar to repair and strengthen the yin and yang corners that are easy to leak, wear pipes, sanitary ware, floor drain and other places, and then use permanent waterproof slurry to do waterproofing as a whole, so that the waterproof effect is better and more durable. >>>More
It is easy to wipe off after soaking a towel in hot water.
If it doesn't stick, you have to pull a layer of wire mesh and then pull it at the same time.
Lightweight bricks are not good for bathroom walls, if they have been made, it is recommended not to hang recuperated water heaters and wall cabinet bath cabinets. The first use of interface agent may strengthen the strength of the brick.
If you want to have a good effect, you can apply the putty layer and then strengthen the primer, harden the putty, and use the water-based paint primer once, and the matte topcoat will look good twice.