-
Anonymous users2024-01-23Lightweight bricks are not good for bathroom walls, if they have been made, it is recommended not to hang recuperated water heaters and wall cabinet bath cabinets. The first use of interface agent may strengthen the strength of the brick.
The bathroom is tiled first and then suspended.
The first is to paste wall tiles, you can choose 30cm 60cm wall tiles, pure white or patterned tiles can be determined according to your preferences. >>>More
Do waterproofing first, then tiling. Remind you of the waterproofing of the bathroom is that the position of the root of the pipe upstairs and downstairs is best done with elastic waterproof coating. This is the area most likely to leak.
See if there is a beam on the top surface of your kitchen and bathroom, the bottom of the beam is pasted to the beam, and the beam height is pasted to about a meter. If you use 300*450 wall tiles and paste 5 and a half pieces, it will be almost the same with the waistline.
Of course, no, the interface agent is mainly suitable for concrete, aerated concrete, small blocks, lightweight partition walls, brick-concrete walls, putty scraping, tile bonding, masonry back coating and insulation board and other reputation delay penetration of the base interface pretreatment. Therefore, it is a material for treating the base surface, not a waterproofing material. >>>More
Of course, the floor drain is installed first, and try to choose a good quality anti-odor floor drain.