-
Anonymous users2024-01-24Putty powder is good. Putty powder with water is environmentally friendly, old powder is used with glue, and glue is not environmentally friendly.
The construction of old powder and glue will be prone to problems after two or three years, and delamination and blistering caused by powder loss.
--Liduo Meixing Coatings.
-
Anonymous users2024-01-23Follow these steps to achieve good results:
1. There are gaps in the gypsum board (board) to be caulked. It is recommended to use a caulk with Texboard Worry-Free Toughness Caulk (TB on) for caulking, which has toughness and can reduce cracking. Allow to dry before attaching the seam tape.
2. Scrape putty powder directly on gypsum board (board) is easy to fall off, and it is recommended to use home Texer board worry-free putty batch scraping for priming (TB), and then scrape putty powder (2-3 times) after drying. If you want to apply latex paint, proceed to the following process.
3. After the surface of the putty layer is polished, apply latex paint.
Gypsum board ceilings need to be painted with latex paint. The gypsum board ceiling is the same as the blank ceiling. Gypsum board can not be directly brushed on the gypsum board, gypsum board is made of two layers of paper sandwiched with gypsum powder, direct brushing will absorb all the moisture of the latex paint into the interior of the gypsum board. >>>More
The main socks with primer are to increase the adhesion of the wall surface of the latex to simple paint, and the color will not appear color difference, so as to reduce the amount of latex paint used without topcoat. If you're not painting a color paint, it doesn't matter if you don't paint it or not.
First, gypsum board ceiling construction procedures: pop up the elevation line on the wall, install the boom, install the main keel, adjust the main keel according to the elevation line, elastic the bottom of the main keel, fix the pay keel, install the cross brace keel, install the gypsum board. >>>More
It's best to make up with all-around putty, and don't paint it again, the place after painting is a patch.
1..The depth of the screw cap is not enough, and the cap head is treated with cement to prevent rust, so this situation is caused. >>>More