How to paste the corner of the bathroom wall tiles to be strict

First, they have to be on site, and workers will not waste tiles too much. If you are not on site when tiling, you will waste a lot of bricks when you encounter those irresponsible plasterers. It is suggested that some imperfect tiles can be pasted by workers in some invisible positions in the future, such as cabinets, washbasins, mirrors, etc., and pay attention to the tiles, waist bricks, etc.

Second, make the wall as rough as possible before tiling, so as to increase the contact area between the cement and the wall. The specific method is to use an electric drill to drill more pits on the wall, the more the better.

Third, when sticking bricks, the bricklayer must be required to pull the line, and supplemented by a level, no matter how good the bricklayer boasts of his craftsmanship and how good it feels, it is recommended that you still insist that he use tools to control the quality.

Fourth, the general load-bearing wall can be covered with cement mortar, but when the kitchen flue, bathroom air duct, kitchen and bathroom are covered with pipes, 108 glue must be added to the cement mortar to increase the viscosity.

Fifth, when the decoration company is tiled, the tile will take a ruler made of a large core board to let you check and accept, in fact, that thing is not standard with a few times, so you can't take that to check the quality of the tiles, you must use a level or aluminum alloy as a ruler for inspection.

Sixth, to prevent hollowing, check that the tile hollow drum can not be knocked just after pasting, it is best to wait for two or three hours before knocking, especially pay attention to the four corners of the tile. I suggest that you should knock one by one, hear the empty drum must be reworked, don't be soft-hearted, because at this time if you make do, and wait until the end of the installation of things to punch the hole in the tile you will know the harm of the hollow drum, then if you hit the tile on a corner of the corner, you will want to cry without tears.

7. The floor of the bathroom must be sloped to the floor drain mouth, and the slope should be increased appropriately, and the original drainage and sewage pipes and floor drain locations should be avoided as much as possible when the bathroom is renovated.

8. If the tile grout is used to match the color, it is best to debug it a little first and then decide the amount, otherwise it is either too shallow or too dark.

9. The slope of the bathroom decoration ground should be considered before laying bricks, and the slope according to the national standard can not achieve the effect of rapid drainage, and if you use an anti-odor floor drain or ultra-thin floor drain, it will greatly aggravate the difficulty of drainage.

10. Don't lay ordinary tiles because the laundry room is not very important, it must be paved. Cheap tiles, which easily absorb water, will have color differences.