What are the basic steps for a suspended ceiling?

Ceiling installation is generally done in steps.

1 Determine the panel length, generally speaking, if the room plan is rectangular, the short side of the rectangle is the panel length, and the panel length is different.

2. Determine the number of panels, the general formula: room length L slats modulus, if there is a decimal place, then round.

3. Determine the ceiling elevation and installation level, premise, ground level or top level for reference. General method: It can be measured with a level; Easy way:

You can use a transparent plastic pipe of appropriate length, fill water in the middle, and connect the water surface at both ends of the plastic pipe, two points and one line, that is, the horizontal line. Measure the elevation required by the project from the ground along the wall vertically upwards (or vertically down from the top), and mark the wall along the horizontal line.

4 Fix the corner strips. Fix the corner strips along the horizontal line with expansion pipes or wooden mule nails on the boards, walls, and curtain boxes.

6. Insert the butterfly hook into the top of the keel first, and then rotate 90° to make the butterfly hook snap into both sides of the keel.

7. Use 4 galvanized steel wires to connect butterfly hooks and metal expansion bolts, and adjust the height of the hook to make the keel horizontal and make the horizontal height of the keel and the corner line of the wall just the panel buckled.

8. The level is more accurate, and it must be achieved: (1) all keels are on a horizontal plane;

2) All keels are parallel;

3) The modulus of each keel is in a straight line.

9. Install the panel, buckle the panel in, and the two ends of the panel fall right in the corner line and press the spring blade. When the last two panels are not installed, a panel against the wall should be installed first, and pressed with a spring sheet, then the last panel should be installed, and finally all the embedded strips should be installed, and the height of the embedded strips should touch the keel.

10. Clean the panel.

11. Miscellaneous.

1) Before installing the ceiling, all kinds of pipelines inside the ceiling must be completed in advance and quality inspection, such as whether the water pipe is leaking, whether the wire is leaking, whether the air conditioner and air duct are unblocked, etc.

2) Before installing the ceiling, the surrounding walls should be completed in advance.

3) Lighting, ventilation, broadcasting, spraying, smoke detectors, etc. must be opened on site and installed synchronously.

4) Installers should wear tulle gloves.