-
Anonymous users2024-01-24The easiest way is to set the IP of the wireless router to the same network segment IP of route A, such as and respectively, and then turn off the DHCP function of router B, define the wireless parameters by yourself, and use a network cable to access the LAN port of route B in any room, so that route B is connected in series on route A, and wants to be used as a wireless switch.
-
Anonymous users2024-01-23Route A:
1. Set up PPPOE dial-up.
2. Set a fixed internal IP address for example.
3. Turn on the DHCP function, for example.
4. Turn on the WDS function, various router configurations are different, please refer to the manual B route:
1. Disable PPPOE settings.
2. Set a fixed internal IP address (for example, different hosts in the same network segment) 3. Turn on the DHCP function (it can also be turned off), and the address range is forbidden to be duplicated with the previous 4. Turn on WDS (pay attention to signal strength problems).
-
Anonymous users2024-01-22If the A route network cable can go to each room, then if you need route B to provide wireless signal coverage, you can only connect the route A network cable to the LAN port of B, disable the DHCP function of route B, turn on wireless and encrypt it.
-
Anonymous users2024-01-21a. You don't need to move the route, directly lead a network cable to the LAN port of your wireless router, and then turn on WPS, WPS has several modes, but you have to use the mode of the access point.
You can try setting up the secondary router again.
There are two ways to connect a router to the router, the simplest is to enter the B router and turn off DHCP, and set the wireless name and password, if the A router is also wireless, then the B router needs to set the same wireless name, password and channel as the A router. After setting it up in this way, connect the LAN port of router A to the LAN port of router B, and the WAN port of router B will be empty there, note that this method needs to enter router B settings first and then connect with router A, otherwise you can't enter router B and still router A. >>>More
Assuming that the cat has a network cable to the two houses, then you connect the cat to the wired router, plug the two network cables into the LAN side of the wired router, and set the router correctly so that the two houses can use the network cable to access the Internet. >>>More
Yes, let the staff who turn on the network lead the line to the living room, connect the router in the living room, if you also watch network TV, you can put the router on the TV cabinet, my home is the weak current box at the door, I put an optical cat in the weak current box, and then lead the network cable to the living room TV cabinet, and then connect the route, so that the whole house can access the Internet. Let the staff give you the network cable, you need to connect a route, and then set it up, it's very simple.
1 All recommended to do this:
2. From the LAN port of the second router to the LAN port of the first router, use the above two steps, and you will definitely be able to realize your idea. >>>More
The radiation of the router with good effect is relatively large, and it feels like the bridge is on the line. For example, a friend's house shares a network with the next door, and a router is installed next door, and the friend buys a receiver and presses it on the outer wall of the two houses, and then pulls in the wire as a wired [to install a wireless network card driver]. >>>More