Urgent! The bathroom has been fine, and after installing the shower to take a shower, the outer wall

Updated on Bathroom 2024-08-13
2 answers
  1. Anonymous users2024-01-24

    There are no problems with the plumbing. It is caused by excessive water consumption at the shower, and of course, it is also related to the lack of waterproofing here. It is recommended to clean up the stagnant water in the bathroom immediately after bathing, and use a plastic sheet to block the shower under the wall when bathing, which can be improved. I hope my answer can help you.

  2. Anonymous users2024-01-23

    How do you check that there is no water seepage in the bathroom?

Related questions
11 answers2024-08-13

Find a few people to run over his house, and the death of a neighbor like this is not enough to make people angry! >>>More

5 answers2024-08-13

It doesn't matter where the water comes from, if you find the water from where it enters your room, just seal the passage, you can use your method to seal the notch, if this is not possible, you have to consider whether the waterproofing of the upper bathroom is not done well.

3 answers2024-08-13

Is a person who grows so big still afraid of cockroaches? You might as well buy a piece of tofu and hit it to death.

1 answers2024-08-13

The solar water heater is equipped with a solenoid valve, which can automatically turn on and off the water, and will not overflow.

1 answers2024-08-13

The reason for the water leakage is that the float valve in the water tank is not closed tightly, and the reason is that the valve seat is not tightly sealed, and the second is that the buoyancy of the float is not enough, and the valve seat cannot be closed tightly, causing water leakage. The solution is to go to a plumbing store or sanitary ware store and buy a new set of float valves, and replace them to solve the problem. Hope to adopt.