Diagram of how to change the inlet valve of the toilet

Follow the steps below to install the tank drain kit.

1. Remove the upper part of the drainage kit first for installation.

2. The upper and lower parts are separated.

3. The screw in the lower part is exposed, and the screw is loosened with a change cone. It should be screwed very loosely.

4. To be twisted like this, the bottom of the zigzag iron sheet (this iron sheet is a little curved and curved) should be placed outside the water tank.

This installation of the toilet valve, I would rather install it for you in the past than describe it in words. I'm afraid you won't understand. Remove the screw on the underside of the valve first.

It's just something under a black rubber pad with a bevel. It is a screw-fastener. I can unwind it.

Then insert the valve into the round hole under the water tank, and then screw the handle on the outside of the water tank and under the valve. Tighten. With the strength of the hand is fine.

No tools are required. If it's gay power, it's enough. This valve is then installed.

Next, connect the hose that receives the water to the water valve. Because it is a screwdriver. So it's also very well connected.

This hose must be tightened with a wrench. Otherwise, it will leak. And so it goes.

I don't know if you can understand. In addition, pay attention to the float of the water supply valve should be directly facing the front of the water tank. It's the white rod, otherwise it would have been a fight with the flush valve.

All right. That's it.

How to replace and install the toilet inlet valve, today I will teach you by hand, and both men and women can easily learn it.

Step 1: Remove the blue integral inlet valve on the left.

Step 2: Remove the cap of the inlet valve.

Step 4: Separate the two parts, and remove them to turn counterclockwise, with the help of small pliers. It is installed clockwise, and it can be installed by pressing it.

Step 5: The following part can be dismantled again, but it is here that the water is closed, and a few copies can be repaired by placing the small transparent lid on it. If you want to try it back after installing it, use the shower head in the bathroom, remove it and install it at the bottom of the water inlet valve.

Step 6: Turn on the shower switch and let in the water.

Step 7: Lift the float and the water stops to prove that it has been repaired. It turned out that in the toilet, the inner float couldn't stop the water from being lifted. Haha, install the toilet back and you're done.

Hope it can help you solve the problem!