-
The problem with the wires is like the light is very bright as soon as the induction cooker is turned on, and it's fine, it has nothing to do with the computer.
-
Voltage, you add a current regulator or something, it has nothing to do with your computer.
-
First of all, see through whether the light load in the bathroom is large.
-
It is a magnetic field that is similar to that generated by a cell phone signal.
Does your home's power switch have leakage protection? If there is, see if the square button of the test jumps out If it jumps out, it means that your bathroom light zero wire and ground wire are reversed Do an experiment Remove the light bulb in the bathroom When the light is turned on If the light is turned on normally, it means that the judgment is correct If the test button does not jump out, then it can basically be said that there is a short circuit Check the bathroom switch light line lamp head Whether there is a short circuit in the place.
This may be the case that the wires of the heat lamp are short-circuited and the wires are burned, which is why the power switch will jump as soon as you connect the heat lamp. You're going to have to change the whole light.
It is very likely that one of the two wires on the lamp head is loose and comes out and hits the other wire, or the water in the lamp head is too wet to cause a short circuit. You can unscrew the lamp head cover and find the cause to rule it out. >>>More
It should be that the valve core of the inlet valve is loose and resonates, so it is recommended to change the inlet angle valve.
That's a few LED lamp beads burned out, and there are two reasons: >>>More