-
Anonymous users2024-01-24There is a way to connect the drain pipe, but it can't solve the problem, the toilet smell is generally not sealed with glass glue below, or the screw hole behind is not blocked (the toilet is equipped with a screw fixed installation hole, but most of them are not used), and the installation can be blocked with glass glue, or it is cracked when the toilet is fired, and there are cracks in the back.
Also, look at your floor drain pipe without a trap, I don't know if you do it below, the water supply of the toilet is generally on the left side of the toilet, and yours is on the right.
-
Anonymous users2024-01-23My family's situation is the same as yours.
Press the toilet master in the drain pad two rubber rings, and then sit on the toilet, my toilet does not smell, I don't know what it has to do with this?
Does your home have an exhaust outlet, maybe it's the smell that comes out.
Hope it helps.
-
Anonymous users2024-01-22If the ground is flat and the toilet flange is round, it will not smell if it can be fully compacted and sealed.
-
Anonymous users2024-01-21It is unlikely that the smell will be bad from the toilet, if the sewer pipe is short, then the first thing is the leakage, and there is a glass glue between the toilet and the floor tiles, so the possibility of bad smell here is not large.
What to do if the toilet sewer pipe is lower than the ground, 1. If your original toilet drain pipe is not very far from the ground finish, such as 2 4 cm, you can directly add a toilet shifter, which is enough to get it. 2. If it is too far from the ground, consider the direct joint, generally the direct joint with a diameter of 110 pipes, the height of which is more than 10 cm, should allow you to not connect other pipes, just put it on the toilet. 3. If the distance between you is too much, you can only connect the direct connection on the shelf and then connect a section of Shanran 110 pipe. >>>More
The toilet sewer pipe is below the ground and can be waterproofed. >>>More
Make a circle of embankment with a little cement on the floor tile of the nozzle (5 mm higher than the floor tile), when installing the toilet, try to align the water outlet of the toilet with the center of the nozzle (to be a concentric circle), so that because the water outlet of the toilet (75 mm) is larger than the nozzle (110 mm), it is difficult for the water of the toilet to flow outside the pipe.
The height of the sewer pipe needs to be raised.
Prepare a suitable diameter of the pipe directly, a new pipe and PVC glue, clean the original PVC pipe out of 3cm length, use special glue to dock the original pipe and the new pipe, the nozzle is 2cm higher than the floor tile floor, and the surrounding area is filled with plugging spirit, and the toilet is reinstalled. >>>More
It can be installed directly with the toilet, and it is recommended to install 2 sealing rings.