The kitchen socket can t be powered, the air opening and electrical appliances are good, not that th

The water heater has a slight leakage, you should focus on checking it, see if the line is still leaking on the water heater, you can also try to pull a new set of wires, if you don't jump is a line problem, I hope it will help you.

There is a possibility of open circuit damage. I've had it. It would be nice to change one.

I have seen it clearly I still suspect that it is a matter of the line You find a three-heart sheath wire directly connected to the original air and ground wire This end is plugged into the water heater Try it If it doesn't work, it is definitely the air leakage protector is out of order.

If there is no problem with the empty opening, it is a problem with the electrical appliances, you remove the grounding wire of the electrical appliances, the grounding wire is marked, the water heater and the range hood.

The leakage protector is not to act by detecting the current in two different directions of the incoming and outgoing lines to cancel each other out as zero, and only one of the wires is used, then the current passing through is not zero and is regarded as leakage, so it trips.

You can pour the kitchen empty to an exception for an empty open, see that it will jump, if you don't jump, it is a quality problem of the empty open. If you still jump, you have to consider the quality of your line, sometimes the quality of the line is not good, with a while, to reach his load heat, will be empty tripping. It is not impossible to open the air without a problem, the air open also has such a phenomenon, if the air open is aging, you use electricity to a certain extent, or reach a certain load, he will jump.

I encountered it when I was photographed for water, I tripped after a while, and finally I couldn't pump it out, after a series of inspections, I found that his air was aging, and it was okay to change the air open.