-
Anonymous users2024-01-24Direct water replenishment is probably in the following situations: the inlet valve is not closed tightly, the drain valve is leaking, and the water level is adjusted too high.
For example, if the plug is crooked, etc., it is good to carefully observe and solve the cause of the water, and replace parts such as Pisai if necessary.
Replace the inlet valve! The inlet valve is available online, check it out to see what type you are!
The drain rubber ring is deviated from the tube below.
-
Anonymous users2024-01-23Keep hydrating because there is a place where the water is gone, such as the plug is crooked, etc., carefully observe and solve the cause of the water walking, and replace parts such as Pisai if necessary.
-
Anonymous users2024-01-22It is the reason for the toilet inlet valve, 1--- there are sand particles that stuck the small gasket in the inlet valve and could not fall, caused by it, find a professional installation of sanitary ware for repair; 2. --- The small gasket of the inlet valve has been aged for a long time and the sealing is not tight, so find a professional to repair it; 3--- The handle chain of the drain valve is stuck, which is also the cause, just take the toilet tank cover off and move the chain yourself. [If none of the above 3 situations are feasible, only replace the water tank accessories].
-
Anonymous users2024-01-21Use the hand to adjust the float valve lever, if you can stop the water ingress, you can adjust the adjustment screw of the float valve, otherwise you have to change the float valve.
-
Anonymous users2024-01-20In order to briefly analyze for everyone, how to adjust the toilet tank and what is the reason why the toilet keeps flowing.
-
Anonymous users2024-01-19The drain rubber ring is deviated from the tube below.
-
Anonymous users2024-01-18Replace the inlet valve! The inlet valve is available online, check it out to see what type you are!
1. Flush switch problem.
You can check whether the flush switch is restored to its original state, because the flush switch in some toilets is easy to wear out after being used for a long time, or it is stuck, so it cannot be restored. Typically, the switch can be reset by repeating it a few times. >>>More
The reason why the toilet flush valve is not closed tightly is caused by the toilet flushing and can be repaired using the following methods. >>>More
Check whether the blue float next to the water supply pipe is disconnected from the water stop valve below, which is generally connected with a rope or chain, and when the water level rises, the blue float will rise, driving the chain to close the water stop valve.
What you touch in your hand is the float rod, but after a long time, you should change to a water inlet control valve, and if the drain valve is easy to use, you can continue to use it.
It is caused by fire crack Check the pipes on all sides of the toilet, if possible, remove the toilet bowl to see if there is a fire crack at the bottom, sometimes there is a leak at the bottom, of course, if there is a problem with the water tank accessories, it may also cause water leakage all the time >>>More