-
Anonymous users2024-01-24Check whether the blue float next to the water supply pipe is disconnected from the water stop valve below, which is generally connected with a rope or chain, and when the water level rises, the blue float will rise, driving the chain to close the water stop valve.
There is a water drift in the water tank, try to move it, it may be that the water drift is stuck, or the water shut-off switch connected to the water drift is broken.
The general toilet will not go up after the water tank is full, if there is a situation that has been on the water, it must be a leak in the toilet, pay attention to observe whether it is in? If there is a water leak, pay attention to him to see what the cause is.
1. Flush switch problem.
You can check whether the flush switch is restored to its original state, because the flush switch in some toilets is easy to wear out after being used for a long time, or it is stuck, so it cannot be restored. Typically, the switch can be reset by repeating it a few times. >>>More
The water tank of the toilet has been on the water, and the small rod will not be on the water, but it can not float up automatically, check whether the linkage between the connecting rod and the water program is separated, or the linkage position is adjusted too high, and the water level rises to achieve the effect of driving the linkage rod, you can readjust the position of the linkage rod to try.
This is most common in the usual maintenance work.
1. The water level is too high and the inlet valve is broken. This is the case where the water can only be stopped by closing the corner valve. >>>More