The toilet button won t go down

Generally, the function of the toilet button is: press the button to drive the zipper through the lever to lift the sewer blockage. If you can't press it, it should be stuck, and the mold excitation cavity will not be able to press the water or the chain will be broken.

The button on the lid of the water tank is asymmetrical with the button of the water part inside, you open the lid of the water tank a little bit, and look in with your eyes, the button on the cover plate can be adjusted to the front and back, left and right.

The bottom of the inside of the water tank can also be adjusted, and the lid is opened The water button is reversed (or there are 2 bayonets, and a clamp can be done by hand) See a screw The Phillips screwdriver unscrews a little until it can be moved, according to your certain amount, press the top and then install it back.

Your toilet is much stronger than mine. A few years ago, my family bought a new toilet, not in a regular place. Everywhere else is good, but the tank is of poor quality.

After a few months, the button couldn't be pressed, and then I couldn't even lift the lid of the water tank, and I didn't get on the water. Later, the water tank was repaired and can be flushed, but it is still necessary to fill it with water before flushing, and once the water tank cover was hit when flushing, and now it is covered with foam, but it is much easier to lift the foam than to lift the water tank cover. My household pipe is connected from the faucet next to the water tank and filled with water before flushing.

It is estimated that the downward pressure position of the button is not pressed to the corresponding position of the water part in the water tank, and the position of the button on the lid can be adjusted (the button on the lid is removable)!