-
Anonymous users2024-01-24Do it before hanging the net, but as soon as the net is hung, the waterproof layer will be damaged, and it is best to repair it again after hanging the net.
-
Anonymous users2024-01-23The practice of waterproofing the bathroom is:
1. Brush the waterproof paint for the first time.
Before construction, ensure that the construction site is clean and dry, and the waterproof coating should be coated with no omission, firmly combined with the base layer, no cracks, no bubbles, and no falling off.
2. Zechang brushes the waterproof paint for the second time. The second pass of waterproofing paint requires a certain time interval and can only be carried out after the paint has dried, depending on the coating.
3. Lay a protective layer. In order to prevent the subsequent construction from damaging the waterproof layer, a protective layer needs to be laid on the surface of the waterproof coating. The protective layer should be completely covered with a waterproof layer, without omission, and firmly combined with the base layer.
4. Closed water test.
During the closed water test, the waterline at the ground point should not be less than 2 cm, and it should be stored for at least 24 hours, and it should be qualified only after observing that there is no leakage.
5. Clean up the base layer and do the leveling layer.
Bonding layer, secondary water storage test.
Yes, you have to hang barbed wire, and then use a layer of sand and gray powder, and when it dries, you can paste it, don't use too much force when pasting, I am specifically pasting wall and floor tiles.
It should be said that the waterproofing is done in the process of decoration, and it is usually done before the tile is pasted. >>>More
If you are required to "hang the net", it must be metal, it is impossible to use non-metallic products, but generally on the brick wall is not very likely to require the possibility of hanging the net, directly with mortar whitewash.
Yes, there is no rule on which one should be done first.
Before laying wall tiles, be sure to do a good job of waterproof treatment of the wall, in the general bathroom waterproof treatment, the wall should be about 30 cm high waterproof coating, if the wall of the bathroom is a non-load-bearing light wall, the entire wall should be coated with waterproof coating. >>>More
The toilet squat bedpan has a low front pressure, which makes it easy for dirt to drain into the sewer pipe from the back.