-
Anonymous users2024-01-24Cantilevered balcony refers to the whole or more part of the balcony stretched out, and there is no load-bearing wall or column at the outermost edge. (i.e. convex balcony: a balcony formed by protruding exterior wall surfaces and picking panels).
A non-cantilevered balcony is a balcony that has load-bearing walls or columns supporting a floor or cast-in-place slab. (Concave balcony: A balcony recessed into the interior of an exterior wall).
-
Anonymous users2024-01-23Hello, the whole or more parts of the cantilevered balcony stretch out, and there is no load-bearing wall or pillar at the outermost edge, which is to pick out the load-bearing or the two ends of the balcony are set up to bear the load, and the floor slab or cast-in-situ is placed on the beam. A non-cantilevered balcony is a sunshine that has load-bearing walls or pillars to support the floor slabs or cast-in-place slabs. If my answer is helpful to you, please give a thumbs up (comment in the lower left corner), look forward to your like, your efforts are very important to me, and your support is also the driving force for my progress.
Finally, I wish you good health and a good mood!
-
Anonymous users2024-01-22Cantilevered balcony: the whole or more part of the balcony stretches out, and there is no load-bearing wall or column at the outermost edge, which is to pick out the load-bearing with the floor slab or set the load-bearing beam at both ends of the balcony, and place the floor slab or cast-in-situ on the beam.
Non-cantilevered balcony: It is a sun with load-bearing walls or columns supporting the floor slab or cast-in-place slab.
-
Anonymous users2024-01-21Look at what kind of wall is underneath the beam.
Underneath the beams are concrete walls, which are non-cantilevered balconies.
If there is a rear wall under the beam, or a window, it is a cantilevered balcony, and the upper floor is probably like this,,, so I will not go into details.
-
Anonymous users2024-01-20I also had a project that struggled with this issue, and finally negotiated to make the frame column support a non-cantilevered balcony!
-
Anonymous users2024-01-19What kind of balcony is this, can it bear 1500 pounds of fish tank?
The height of the cantilever beam can generally be taken L 8 L 4. >>>More
upper part 3 - diameter 25 steel bars, protruding into the side wall beam or frame beam 2 meters; >>>More
It has nothing to do with the length, it is the tendon in the width direction! One end extends into the inner floor slab of the beam 500 anchorage, the anchor end is 90 degrees hooked, the balcony outside 180 degrees hook, 16 threaded steel bars 150 are evenly distributed at intervals, the distribution of steel bars in the length direction is not subject to any force, 12 reinforcing bars are evenly distributed at intervals, and the reinforcing bars are arranged near the upper surface of the balcony slab, the thickness of the protective layer is 25, and the rebar grade is HRB335.
To carry out the overturning calculation, there is no ring beam addition, generally extend into the wall 2-3 times the length of the pick-out.
Please don't worry.
Attached lifting scaffolding and cantilever outer frame with a height of more than 20 meters belong to sub-projects with greater risk of more than a certain scale, and a special safety construction plan must be prepared before erection, which is approved by the expert group. During the demonstration, it is necessary to review whether the nodes supported on the structure have been reviewed by the original design unit or have been strengthened in advance; >>>More