-
Anonymous users2024-01-24The process you said is not right, to put it simply.
1.Clean up the dirt in the base layer and remove protrusions.
2.Check whether the base layer is hollow and loose, and repair it if so.
3.Yin and yang angles should be made in a circle or arc shape, and sharp angles should be avoided.
4.All kinds of pipes, sewer pipes, floor drains, casings, sanitary ware roots, and yin and yang corners should be waterproofed first.
5.The first pass is perpendicular to the direction of the second pass.
6.The waterproof height of the ground should be 300 mm, and the height of the wall should be 1800 mm.
Several indispensable steps for decorating the bathroom to do waterproofing must not be ignored. >>>More
Waterproof coating is better. If the pipe is irregular when using the membrane, it will increase the difficulty of the construction of the tarpaulin, and the tarpaulin will not have adhesive force, and it is easy to produce seepage and leakage in the humid environment of the bathroom. It not only reduces its waterproof effect, but also affects the aesthetics of the entire waterproof layer of the bathroom, if you use waterproof coating, the operation is simple and convenient, and the waterproof is very good.
It is a human thing, how much will be unsatisfactory, and whether the water leaks in the later stage depends on your actual use and how to maintain it in the later stage.
First of all, the ground has to be leveled, 30 cm from the ground wall tiles are also removed after leveling, to dry, two kinds of waterproofing: membrane, coating, if you use membrane, it is best to use EPDM waterproof membrane, if you use paint, it is best to use rubber modified asphalt waterproof coating, the ground and wall are done together, after doing it is like a basin, it is best to paint three times with paint, the main part is the floor drain pipe mouth, toilet pipe mouth, the ground and the wall joint, the weak part of the ground, do it carefully clean the pipe mouth with a toothbrush, Rinse while brushing, clean with waterproof cement carefully wipe the ground and the joint of the pipe mouth, the water does not leak inside the best to add some asbestos powder, after thoroughly drying and the ground together with the overall waterproof, the toilet fixed wire should be laid first, more than one centimeter from the ground The mouth of the screw is wrapped with masking paper and do not stain the waterproof coating, the following part is also brushed with the ground with waterproof paint to prevent the water from seeping down the fixed wire in the future, and you can put the water after drying, soak for 48 hours, the water should be 10 cm deep, otherwise it will be tried in vain, You said that the plumbing pipeline in the seal before taking a few photos, in case there is a problem in the future can check the location, with the high grade cement all sealed and leveled, the key is that the cement must not be bought fake, otherwise it is also done in vain, good cement looks blue after drying, high density, high hardness, high strength, not easy to leak, do not use white cement to make up the seams after sticking the floor tiles, you go to buy a few bottles of Taimao brand plastic steel clay, but also to prevent not to buy fakes, floor tile joints, wall corner joints, etc. are all made up with plastic steel soil, if you do this, There is absolutely no possibility of a water leak in 10 years, unless the house settles and causes a slight crack in the ground, and then raise the problem. I wish you success! >>>More
1.According to the regulations, if the bathroom has a shower area, the waterproof height of the wall should be meters high. >>>More