-
Section-by-paragraph elimination.
First disconnect all the loads that can be disconnected first, and disconnect them first if they can be dialed out.
Then check a section of the line, because the wiring must be multi-way, such as a switch laid to another switch is to connect a part of the wire into the first, to see if there is a leak, and then connected, until find out which section, the focus is not to see whether it is caused by the load, check whether the line is cut through the wall, etc., whether it is immersed in water.
Is there a joint, whether there is a rat bite, whether there is a hole in the decoration and the line is broken, etc.
-
The leakage protection switch will jump, and after the power is off, shake the insulation of each line with a shake meter.
-
One is connected to the wire, and the other end is connected to the leakage point.
-
How much does it cost to ask a professional master for kitchen leakage.
-
The electric detector is generally available in the toolbox.
If it is a leak in your home, quickly turn off the water and find an electrician or property; If it's a leak in the upper floor of your house, go up and look for it directly, and I don't understand what to ask here.
Have you not installed a door stone Just use alloy metal strips at the junction between the living room and the bathroom for the transition. >>>More
If you rent a house, whether it has been renovated or installed by the landlord, if it is the landlord, the water leakage situation will be dealt with directly by the landlord. >>>More
It seems that you can't claim because you didn't decorate and didn't cause damage. However, the developer and the property can be asked to repair the quality of the house, and if it is not repaired, it can be complained to the housing management department.
Some time ago, there was a fuss in my bathroom, and it came in through the exhaust port of the bath bomb. Just take apart the gusset, buy a fence, and seal the exhaust pipe and the hole in the wall outside.