-
Anonymous users2024-01-24Take off the piece on the edge first, the method is to squeeze the gusset along the horizontal direction to the middle of the room, and then push the edge of the gusset to the top, the plastic gusset is soft, so that you can remove the first piece, and then it is not difficult, the corner line is nailed to the wall with nails, and the nail should be pulled out first with pliers.
Of course, this needs to be sewn, it must be good for Fengtai, not bad for sewing.
The last piece is determined, cut the size, and if there is a notch, just insert it inside.
The corner line of the ceiling is finally fixed at the junction of the wall tile and the gusset with glue after the gusset is installed. If the disassembly can only be forcibly removed, it may be damaged. However, reinstallation is simple and inexpensive.
Cut the glue of the corner with a knife and then disassemble it, du has a buckle zhi stuck on the keel, and pull down a little bit to go down the version. >>>More
The strip gusset ceiling system is composed of decorative panels, special auxiliary keels for strip gussets, upper light steel main keels and related accessories. The decorative panel is divided into C-type seamless bar buckles, and G Aomet is mm. The gusset plate is made of continuous roll forming, and the conventional maximum length size is 8000mm. >>>More