How to deal with a leaky flush toilet

Updated on Toilet 2024-07-10
4 answers
  1. Anonymous users2024-01-24

    Re-install the internal fixtures, or replace them with new ones.

  2. Anonymous users2024-01-23

    1. The common reason for the leakage of the flush toilet is that the hemispherical rubber cover that covers the drain is light, and the water leaks due to insufficient gravity and is not tight enough when it falls after the water tank is discharged, and it often needs to be repeated many times to cover it tightly. The solution is to bundle a little heavy object on the connecting rod connected to the rubber cover, such as a large nut, toothpaste skin, etc., and pay attention to the bundle as close as possible to the rubber cover, so that the rubber cover is easier to cover the drain, and the water leakage problem is solved.

    2. After checking the inside, check the connection of the water tank, there is an interface where the water tank is connected, and this interface is connected to a hose. If the seal is not good in this area, or if the rubber pad inside is aging, it will cause water leakage. When checking the interface, you should be careful, and check it several times to determine the problems in it.

    3. If there is no problem with the internal equipment, check the outside of the water tank to see if there are cracks in the water tank. In the process of transporting the toilet, there will be some imperceptible cracks due to bumps, and after a period of use, these cracks will gradually seep water. Therefore, checking the integrity of the tank is also the key to dealing with water seepage.

  3. Anonymous users2024-01-22

    The water stop valve in the toilet tank can't go back. Remove the toilet tank lid and manually pull the water stop valve or pour water directly into it to help it get back into place.

  4. Anonymous users2024-01-21

    It depends on the leakage, if the toilet itself leaks, you have to buy a new one, and the base can be glued if it leaks.

Related questions
What to do if the toilet tank is leaking
2 answers2024-07-10

There are two reasons for the leakage of the flush toilet tank, the first is that the water is full and cannot be closed, which is solved by turning the float valve low. The second is that the water tank is leaking while the water is ingress, this is because the plug did not reset when you flushed last time, and you can press the flush button again and it will not leak.

How to deal with leaking toilet outlet valves
1 answers2024-07-10

If the water valve is a flush injector, you can close the valve, open the flush injector, clean the internal valve core, dirty and sand seals are not strict, if it is a water storage tank, it is the most important to explain the current situation of water leakage or equipped with a picture in the water tank to accurately analyze and answer.

How to tell if a flush toilet is leaking
1 answers2024-07-10

Usually, there is stagnant water on the ground around the toilet bowl, and there is stagnant water for a long time, which proves that the flush toilet is leaking.

Flush toilet leaks
32 answers2024-07-10

That is, there is a problem with the plug of the drain outlet of the water tank, and it should be ...... that the flush port cannot be re-blocked by its own weight >>>More

What to do with the gray dirt on the flush toilet
2 answers2024-07-10

There are special toilet cleaners for sale, and the decontamination power is very strong.