What should I do if the pressure of the water tank used for bathing in the bathroom is not enough

The fittings in the water tank can be adjusted, the water outlet lever can control how much water should enter the water tank, and the flush valve can control the amount of flushing. So you can try it out. Put water in more points or water flush more points.

Two possibilities:

One is that the main water valve in your house is broken and not all opened, resulting in low overall pressure. This can be judged by looking at the stress situation in the kitchen and elsewhere. That's the problem if it's small, otherwise it's not. >>>More

Whether it is a toilet or a squatting toilet, if it is a toilet, see if the water level of your water tank is too low, you can adjust it a little higher, and it may be that the design of the toilet is not good, which will also lead to a bad flushing effect, if it is a squatting toilet, then it depends on the size of your water tank and the water level of the water tank, and if the water tank is installed too low, it will also lead to low pressure, you can find a water worker to help you see.

Temporarily pull a socket for the power cord in other positions to use, and when the position is determined and will not be changed, you can find a way to make a section of open wire from other power sources to use.

If you buy an electric water heater, if you want to buy an electric water heater, you can use a plastic bucket to mix it with acceptable warm water, and then install a shower head and rinse it, and use a thermal insulation bucket to wash it with warm water as above. >>>More