What should I do if the solid wood floor is bulged up by blisters and cannot be put back in place? I

Updated on Solid wood 2024-07-06
3 answers
  1. Anonymous users2024-01-24

    It's hard, it's hard! The solid wood floor is dried by logs in the drying room, like the wooden floor of your house is blistered, my opinion is that it must not be cut, so you can never make up for the paint! My opinion is to sell another piece of flooring, your house should have just been renovated not long ago!

  2. Anonymous users2024-01-23

    I would like to say. How big you bubbled. If you use sandpaper to grind the handle, it is a good choice to use a grinder. If it's a piece of two. Later, when there is a gap in putty, I basically can't see it.

    Lots of words. You'd better wait for him to shrink back and get it... Recently, the rainy season has just passed, and this situation is normal.

    Well. Dry wooden floors?。。 Basically, it's good to dry it.

    The dried wooden floor cracked in the previous life, because the moisture ran out of water and shrunk all of a sudden, and it was estimated that it could be used as firewood.

  3. Anonymous users2024-01-22

    You can't saw, and after a while, the sawing place is a gap.

    If every floor is soaked, there will be gaps between the floors in the future.

Related questions
3 answers2024-07-06

First, check the shrinkage joints between the floor and the wall. >>>More

2 answers2024-07-06

One of the more common ground arching is the arching caused by the lack of expansion joints. Because the wooden floor does not leave enough gaps in the joint between the wooden floor and the wall root when paving, the floor expands after being damp in the rainy season but does not have enough elastic expansion space, so it is naturally arched. It is typical that the wooden floor that is arched when the foot is stepped on will collapse, and when the foot is raised, the wooden floor will arch again. >>>More

3 answers2024-07-06

The floor should be removed immediately, because it is a solid wood floor, there is a keel underneath, so it must be removed, let the keel dry, and reinstall it after drying it upright indoors, it is strictly forbidden to use an electric heater to dry or expose it to the sun, and it is not possible to reuse it if it is deformed and warped, it is recommended that it is best to ask a professional to help you go to the scene to see.

5 answers2024-07-06

If the floor is already wet, be sure to open the floor, stand upright in the room and dry it naturally, if it is not deformed, it can also be installed and continued to be used, if it is deformed, it can only be replaced with a new one. Be sure not to dry in the sun or hair dryer. It's best to find a professional to come to the site to take a look and make an assessment of the loss, which can be used as the basis for future claims.

5 answers2024-07-06

Get the water away as soon as possible, and then quickly disassemble the floor foundation to dry without completely penetrating the back. >>>More