What to do if the hardwood floor is blistered

If the floor is already wet, be sure to open the floor, stand upright in the room and dry it naturally, if it is not deformed, it can also be installed and continued to be used, if it is deformed, it can only be replaced with a new one. Be sure not to dry in the sun or hair dryer. It's best to find a professional to come to the site to take a look and make an assessment of the loss, which can be used as the basis for future claims.

First, if it is severe, it may be deformed.

This responsibility naturally rests with the residents upstairs, but I think it's likely to be a ramp, and if possible, it's better to re-pave it.

Two. The stress of the variant is not too great.

If there is an air hole, you can use a hair dryer and low hot air to dry it slowly in the nearest air hole, and divide it into several times.

Of course, the responsibility lies with the residents upstairs.

If it is a general floor, please first lift up the place that can be lifted, keep it ventilated, and it is best not to bake it with heating

Get the water away as soon as possible, and then quickly disassemble the floor foundation to dry without completely penetrating the back.

Then spread a layer of plastic and put it up again.

The premise is that the floor has not been deformed and warped.

Otherwise, it will be difficult to put it back together.

When it dries, your furniture and floors will also break. Now you immediately take pictures for evidence, so that you can reason with the upstairs in the future.