-
Anonymous users2024-01-24In the process of construction, it is no problem to simply hang upside down, and the big white plus latex paint is enough to cover up. If you have time, it is advisable to re-hang it, as the reverse side has a different effect on paper and may cause a reaction in the future.
If there is still a color difference after all is done, buy a small bucket of good quality latex paint and repaint it without mixing it with water.
-
Anonymous users2024-01-23Scrape a few more layers of putty, and then apply latex paint with a better coverage rate, there should be no problem.
-
Anonymous users2024-01-22Either dismantle it and re-remove it, or spray some paint on it.
-
Anonymous users2024-01-21There is no problem if the seams are glued well.
Here's how to fix it:
1. Laying direction, transverse and longitudinal fixation, the strength performance and deformation of gypsum board are determined according to the direction, the longitudinal performance of the board is superior to the transverse, so the ceiling is not allowed to be parallel to the longitudinal and overlying keel, should be perpendicular to the keel, gypsum board must be installed in a stress-free state, the installation of the ceiling board is temporarily supported by wooden support, and the board is pressed with the skeleton, the support can be revoked only after the screw is fixed, and when the fixed plate is installed, it is fixed from the middle of the board to the four sides, and no more points are allowed to work at the same time. >>>More
Is it asking about the construction process or the way of construction? >>>More
I think it's a bit of a hassle for you to do it yourself. >>>More
(1) The surface of gypsum board should be smooth, and there should be no defects such as pollution, cracking, missing edges and corners, hammer wounds, etc., and the joints should be uniform and consistent. (2) The gypsum board that is shelved and installed shall not have leakage, transparency and warping. (3) The hole spacing of the perforated plate should be neatly arranged, the perforation should be perpendicular to the dry plate surface, the cinnamon edge should be a right-angled plate, and the side should be at a right angle to the plate surface. >>>More
That is the top surface of the moisture, water vapor, there is a wooden keel where there will be white, no keel will be dark, the reason may be that the roof ventilation is not good, the quality of the gypsum board used in the ceiling is too poor, the solution: 1, the cost of re-ceilinging is too high 2, re-scrape putty, paint, treat the symptoms but not the root cause, in a few years will be like this, 3, if it does not affect the use, make do with the use of it,