There is no water in the flushing toilet tank, what is going on and how to solve it

There is a problem with the plumbing.

Check the pipes connecting the tank to the outlet to see if they are loose.

Or the switch is turned off.

If it's all right.

Find a maintenance master.

It doesn't seem to be a problem with the squatting toilet, there is a problem with the water inlet pipe.

First of all, pull down the pontoon of the inlet valve by hand to see if the water can be restored, if not, then.

Close the angle valve, disassemble the hose, and see if the filter at the inlet of the inlet valve is blocked by stolen goods.

Some angle valves also have filters to check, and if there is a blockage, clean and install them back.

Check to see if there's a problem with the water parts!

The water inlet valve is broken, and the water will not stop.

The inlet valve is blocked, just clean the inlet valve.

The water inlet pipe is blocked by something, or the toilet is broken.

Answer: If the button on the toilet tank lid does not respond, first of all, we should find out what the cause is, and deal with it according to different situations. If it is difficult to press the button on the lid of the toilet tank, or it is very loose after pressing, it has no effect. Then it is very likely that the spring in the toilet button is rusty and aging, or it is possible that the button is stuck by some debris, in the face of such a situation, it is relatively simple to deal with, we only need to replace the button of a toilet tank.

It may be that the toilet tank can be flushed after pressing, but the amount of water is very small and the momentum is very small. Whether the water level is sufficient to reach the amount of water flushed. If there is a problem with the water level, it is possible that the inlet valve is faulty.

And not the malfunction of the toilet tank button. In this case, the inlet valve should be checked to a certain extent.

If it is determined that the toilet tank button has failed, then there is only one replacement, which is actually a relatively simple operation. We should turn off all the water in the toilet, then drain the water in the tank, and then remove the entire lid of the toilet tank, and then remove the button part of it and replace it with a new button.

Question: There is no water tank on the toilet.

One hand and one foot press.