-
Anonymous users2024-01-24The following diagram can be referred to: if the solar position is very high, the booster pump can be replaced with a valve, which can be controlled at will. A valve is also added under the tee to control them separately.
Method 1: Close the main water valve first, and then put the faucet handle with a red and blue mark of about 8 mm, buckle it down, loosen the fixing screw counterclockwise with a flathead screwdriver, take off the handle, use a live wrench to disassemble the valve core of the faucet, open the upper part of the gland with a wrench, and take out the ceramic valve core inside. >>>More
There are 2 hot and cold water pipes, and the corresponding outlet pipes are also 2, which can be connected to each other.
Step 1: Prepare your tools first: screwdriver, wrench, pliers. >>>More
According to what you said, depending on the water pressure problem, the remaining two reasons are the first two reasons, 1 is that the pipeline leading to the kitchen may be blocked, 2 the cold water angle valve or the mixing valve of the sink has a problem with the cold water diameter or blockage. You can first swap the water inlet pipe and angle valve of the mixing valve (on the outlet of the angle valve or on the faucet water inlet), if the cold water becomes larger and the hot water is smaller, it is the problem between the angle valve and the mixing valve, if it is exactly the same after the change, the water pressure and flow rate from the wall are small.
The kitchen faucet hose is generally the first to fix the faucet of each part of the rubber pad, from top to bottom into the hole of the water cold, and then use a hollow flange child near the bottom of the faucet at the end of the faucet to tighten the connection with the disc body is strong and firm, and then tighten the interface at the bottom of the hose clockwise.