-
Anonymous users2024-01-24The seat and seat are installed and replaced in one piece, and most toilet seats are installed as follows:
1. There are two holes under the ceramic part of the toilet bowl and the movable shaft of the cover plate, (generally after the cover plate is installed, the two holes are hidden under the cover plate shaft, and you can't see it, so you don't know that the ceramic part below actually has two holes);
2. Two plastic clips, from top to bottom through the screw nut, are installed on two holes, and the clips are on top. This needs to be screwed from under the back of the toilet, if the toilet is against the wall, it is a little awkward to put your hand in, try it, if it doesn't work, you need to move the toilet out, install the clip and then install the toilet;
3. Put on the clip, correspond the toilet seat to the clip, and push it from right to left. Adjust the toilet seat card slot slightly to about the same distance from the clip.
4. If the cover is only broken, you can push the cover from left to right, and you can remove the bad one and install the new cover directly.
-
Anonymous users2024-01-23The seat and cover are installed and replaced in one piece, and most toilet seats are installed in the following ways:
1. There are two holes under the ceramic part of the toilet bowl and the movable shaft of the cover plate, (generally after the cover plate is installed, the two holes are hidden under the sail source of the cover plate shaft, you can't see it, so I don't know that there are actually two holes in the ceramic part below);
2. Two plastic clips, from top to bottom through the screw nut, are installed on two holes, and the clips are on top. This needs to be from the back of the toilet messy under the nut, if the toilet is against the wall, the hand into it is a little awkward, try it, it really doesn't work, you need to move the toilet out, install the clip and then install the toilet;
3. Put on the clip, correspond the toilet seat to the clip, and push it from right to left. Adjust the toilet seat card slot slightly to about the same distance from the clip.
4. If the cover is only broken, you can push the cover from left to right, and you can remove the bad one and install the new cover directly.
Dizzy. There are two small holes on the inside of the toilet seat, which are pressed into the screws. The one in my own house has two screws. The nut is in the bottom. You can feel it by going down and inside the tank. Release it and you can remove it. Then press the one you bought.
The toilet seat is made with a check valve and a miniature hole on top of the piston inside a small sealed plastic cylinder. When lifting, the air passes through the check valve, and when it falls, the air passes through the small hole to achieve the effect of slow falling.
Whether it is a smart cover or an ordinary cover, if it is ordinary, it should be divided into models, and the key is that the expansion screw should be tightened.
If the toilet is not installed, you can install the toilet lid on the back of the toilet, which is more convenient and convenient to install, but if the toilet has been installed and fixed, it is necessary to dig out the installation from the back side, which is more awkward, but it can only be installed in this way.
Toilet seat, I think Jiumu's is very good, I have always used this brand, and there has been no problem at all for a few years.