What is the reason for the low flushing force of the toilet

Under normal circumstances, any flush toilet, 4-5 years of use will be fouled, the original smooth ceramic surface of the fouling, it seriously affects the drainage capacity of the toilet, resulting in the inability to flush in time, slow drainage, which is usually caused in the process of use, generally the only longer way to appear this phenomenon is to replace the toilet, even if it is descaled in various ways, the siphon elbow inside the toilet can not be completely removed, there is a temporary improvement, and this phenomenon will still appear after a while.

First of all, it is forbidden to urinate in the toilet, even if it is necessary or unavoidable, it is necessary to flush out the urine in time, do not be afraid of water, and secondly, you should not throw the paper into it after unraveling it; In addition, there is a subsection on the installation, that is, the toilet outlet must have a certain amount of water, if after flushing, the toilet outlet is always only a little bit of water left and even the outlet has not overflowed, so that the use will be directly stained on the surface of the ceramic dirt, and unhygienic and troublesome.

In summary, as long as you pay attention to the following points, you can use it for more than 10 years or more, except for general wearing parts.

Urinate frequently. Don't throw away paper sheets.

Wash frequently, but do not use sulfate hydrochloric acid, which will directly lead to damage to the ceramic surface.

Hello, according to what you said about the small flushing power of the toilet, I will make a specific analysis: 1. The water storage level in the toilet tank is not enough, and the amount of water when flushing is not enough. Workaround:

Gently open the cistern lid on the back of the toilet bowl and find the float water level regulator to adjust to the maximum. 2. The button flushing fulcrum on the toilet tank cover cannot fully contact and squeeze the flush valve in the toilet. Workaround:

Gently open the water tank lid on the back of the toilet bowl and check whether the fulcrum of the flush button is aligned with the flush valve in the toilet bowl and is not aligned and adjusted; Check that the flush button pivot and the flush valve in the toilet bowl are fully squeezed when squeezed, and adjust the length of the flush button pivot if not. 3. Consider whether the water is slow. Workaround:

Remove the toilet, dredge the drain and restore the toilet.

Is it a problem with the water outlet?