-
Anonymous users2024-01-24There are many reasons why a toilet leaks can occur.
It may be that some parts of the tank are aging, and it is good to replace them.
It may be that there is a leak in the connection between the toilet bowl and the sewer, and it is more troublesome at this time, so you need to reinstall the sealing rubber on the toilet.
It may be that there is a crack in the toilet, and if this is the case, it is necessary to replace the toilet.
It may be a problem with the drain valve, and it will be fine to re-fix it.
There are two situations of water leakage in the water tank, 1: the outlet valve is leaking, the inspection method is to close the water inlet triangle valve, if it has been leaking, it is the leakage of the water outlet valve, just see whether the seal is deformed, or there are impurities; Another situation is that the button does not pop up, open the water tank lid to make it pop up, generally there is debris stuck, just clean it. 2；The water inlet valve is not closed tightly, the water has been added to the water tank, the water flows out from the overflow port, and the water inlet triangle valve will not flow again after the water inlet valve is closed, but the water in the water tank is still full, you can judge that there is a problem with the water inlet valve, and this situation can clean the valve seal.
1. The water inlet valve does not enter the water.
1) Check whether the tap water pressure is too low. >>>More
It is possible that it is recommended to contact a toilet installer to help you reinstall it. This problem may be caused by the seal not being perfectly aligned with the drain pipe.
According to the analysis, it should be to control the leakage of water at the cover plate where the drain can be lifted (as shown in the figure). After pressing the drain button, you can hear the sound of the lifting cover closing the cover, indicating that the cover plate and the connecting rod can be lifted freely without jamming. When the water is replenished and the water leaks in the middle of the water, it should be that the two internal pontoons that control the semi-drainage and full drainage are raised by the buoyancy and jack up the connecting rod to drive the cover plate up, and the cover plate and the water outlet have a gap, resulting in water leakage. >>>More
If the water is leaking under the water tank, replace it with a shut-off valve of the same size (generally a rubber one in the middle of the bottom of the water tank).