The tiles in the kitchen are cracked, is it because of the quality of the house

If there is a long crack in the penetration of multiple tiles, it is at least related to the quality of the wall; If the wall cracks together, the least problem is related to the quality of the wall foundation.

If it's just discrete tile cracking, that's a different story:

1. In essence, it is a large difference in tensile strength between ceramic tiles and 'bonded' cement, and there is a stress difference between thermal expansion and cold contraction after the cement is cured, which may crack because of aging.

In this case, I knocked out all the tiles that had discrete cracks in the bathroom and replaced them with the same thin tiles, and after a few years, they cracked again. In this case, the quality of the wall is completely excluded. Later, I realized the above and the following.

It is estimated that it is more likely that the thickness of the tile in question is too thin

2. Note that it is easier to crack with high-grade cement - because the tile bucket is not high-strength cement. The solution:

Switch to genuine cement with general grades, as long as it does not fall off [the adhesive area is large enough to guarantee!] ]。

It is also necessary to ask an experienced plasterer expert to be sure.

3. Because of the tiles used for today's walls, the thickness is relatively large, and there are rib mesh structures behind them that increase the bonding strength and area.

Hope to throw bricks and feedback with feedback.

Tile cracking is because the tile is a perishable item, maybe when you buy ceramic tiles, the marketer will say that our tiles will not crack how to so the quality of the tile is the most important, the second is that the installation is not standardized, the cement mortar is not uniform enough. Tiles are to leave gaps, must enter the heat rise and shrink of the cold.

You don't tell how the crack is, whether it's along a line or in an area, where holes have been made and patched in the wall, or where there are water connections.

There are several possibilities:

1.Most likely, the wall has been shaken, for example, a neighbor has been decorating and has smashed the wall.

2.The place where the tile is broken has been collided or is too close to a heat source such as a stove, and the heat expands and contracts.

3.Generally, no matter how bad the quality of the wall is and how bad the quality of the tiles is, they will not crack, and only the tiles may fall off.

Tile cracking is generally a problem in the house, pay attention to observe whether there are cracks in the wall next to the tile. It is connected into one.

Land subsidence can cause cracking. Subtle settlement can cause cracking. If it settles significantly, it will be terrible, and the stones and bricks will crack.

Housing disputes can be coordinated with the housing management office and the consumer council, and if the coordination fails, it will be a lawsuit.

Don't think about it so seriously;

The quality of the tiles is average; The height of the cement gray number; The cement stretches the tile during the drying process, and the tile cracks under force.