-
Anonymous users2024-01-24Hello! The installation of squatting is mainly to do a good job of waterproofing the outlet of the squatting outlet, backfill to stop 5 cm from the squatting level, and then use cement to pave the floor tiles. If you don't pave the floor tiles, the proportion of ash and cement should be more, and the bathroom does not need to do anything special waterproofing, because the floor slab of the bathroom is poured and has played a waterproof role, so there is no need to do special waterproof treatment, you just need to do a good job of waterproofing the outlet.
-
Anonymous users2024-01-23The friend upstairs said carefully, not to harm others.
The bathroom is the place where the most open water appears in the family, and cracks are easy to appear due to the settlement of the foundation and the problems of construction, so the use should be waterproof.
Waterproofing is done on the backfill layer, and then a squatting toilet is installed in the subsequent construction. The waterproof layer is done in the first installation of home decoration in the water and electricity installation has been installed on the water inlet pipe and outlet pipe generally, the general painting height is more than 10.
Leibangshi - home waterproofing expert.
-
Anonymous users2024-01-22No, before paving the floor and turning the ground, it is necessary to do a good job and do a water seal test before laying bricks, and then install the toilet, the discharge port of the toilet is inserted into the inside of the sewer pipe, and has nothing to do with the water discharge.
-
Anonymous users2024-01-21The installation of squatting is mainly to do a good job of waterproofing the outlet of the squatting outlet, backfill to stop 5 cm from the squatting level, and then use cement to pave the floor tiles. If you don't pave the floor tiles, the proportion of ash and cement should be more, and the bathroom does not need to do anything special waterproofing, because the floor slab of the bathroom is poured and has played a waterproof role, so there is no need to do special waterproof treatment, you just need to do a good job of waterproofing the outlet.
Usually the toilet in the building is based on the size of the squatting toilet to solve the problem of reducing the elevation, generally the maximum is only 400, the common residential is about 300, with cinder concrete filling, so the beam elevation of the bathroom also needs to be reduced. Washrooms, kitchens, balconies and other areas that are prone to water accumulation should be lower than the elevation of the same floor. >>>More
Toilet waterproofing should be done before the installation of the squatting toilet, not after the installation of the squatting toilet. >>>More
Anti-seepage agents can be injected by punching holes in the top of the bathroom downstairs. I hope my answer can help you.
I have a friend who is engaged in decoration, and I will help you get in touch.
1. There will be no problem with all, after doing waterproofing, if there is no decoration, it must be maintained with water, otherwise it will dry out. >>>More