How to solve the vibration of the water pipe when the toilet is pumping

Updated on Toilet 2024-07-09
1 answers
  1. Anonymous users2024-01-24

    1. The resonance phenomenon is because when the flow frequency of water is the same as the intrinsic frequency of the water pipe, the amplitude is the largest, that is, it will make sound. The only solution is to change the quality of the water pipes.

    2. The phenomenon of resonance refers to the tendency of a physical system to absorb more energy from its surroundings at its natural vibrational frequency (the so-called resonance frequency). There are many places in nature where there is a phenomenon of resonance. Humans are also using or trying to avoid resonance phenomena in their technology.

    Some examples of resonance are: acoustic resonance of musical instruments, orbital resonance between moons of some Jupiter-like planets in the solar system, resonance of the basement membrane in the animal ear, resonance of electrical circuits, etc.

Related questions
1 answers2024-07-09

You should be in the country, and the weakening of the suction is mainly a matter of reduced air pressure. It is also possible that the U-tube is clogged. The former is more likely.

2 answers2024-07-09

There are two possibilities.

The first is that the water tank is too high, and the height of the water tank can be lowered appropriately. >>>More

1 answers2024-07-09

The toilet drains slowly because your house is on the first floor, or you have changed the original squatting toilet to a toilet, forming two traps and causing insufficient suction. To solve the problem, as long as the original water trap below is removed, the suction power will be larger.

2 answers2024-07-09

Clause.

1. Preparation for the installation of the flush toilet Before installing a flush toilet, the following 5 preparations should be made: first, check the level of the ground where the toilet is installed; The second point is to check the sewage pipe of the toilet bowl and remove the debris in the sewage pipe; The third is to leave a distance of 2 to 3 mm above the ground at the sewer outlet; The fourth point is to check whether there is any leakage in the water pipe and debug and install the water tank accessories. Finally, it is necessary to test the sewage effect of the toilet, if the water is flushed very quickly, it means that the drainage is not smooth and there is a blockage. >>>More

6 answers2024-07-09

The toilet cannot be pumped.

1.The toilet tank is not at the same level. >>>More