-
Anonymous users2024-01-24E1: Ignition failed or stalled halfway.
When the flame detection (feedback electrode) induced current is weak, it is judged that there is no fire in the burner, and the program is interrupted. At this time, you can check whether the feedback electrode is in the high temperature area of the flame, adjust the height of the feedback electrode, and check the connection line and plug of the feedback electrode.
Observe the combined electrode from the window for discharge. In this case, the discharge distance of the combined electrode can be checked, and the connection and pulse generator can be detected.
If you still have questions, it is best to look for after-sales service.
-
Anonymous users2024-01-23The solution is to descale regularly, buy a gas water heater online without removing the scaler, it is a matter of dozens of pieces, use it to inject descaling agent into the water heater to clean the inside of the water heater can be descaled, the operation is simple and convenient, many people have used it, it is really effective, and it will be used to clean the water heater regularly in the future, when this problem can be avoided again.
E1: Ignition failure or flameout in the middle of the process When the flame detection (feedback electrode) induced current is weak, it is judged that the burner is not on fire, and the program is interrupted. At this time, you can check whether the feedback electrode is in the high temperature area of the flame, adjust the height of the feedback electrode, and check the connection line and plug of the feedback electrode.
Observe the combined electrode from the window for discharge. In this case, the discharge distance of the combined electrode can be checked, and the connection and pulse generator can be detected.
Solution: Midea water heater fault code 1, E1: ignition failure or flameout due to the weak induced current of the flame detection (feedback electrode), it is judged that the burner has no fire, resulting in the interruption of the program.
At this time, you can check whether the feedback electrode is in the high temperature area of the flame, adjust the height of the feedback electrode, and check the connection line and plug of the feedback electrode.
The position of the flame-out protection induction needle is not very right, a little wind and fire are moving, you can't sense the fire, the solenoid valve is closed, that is, the fire is out, it is recommended to adjust the position of the induction needle, and then it will be better to buy professional brands in the future, such as: Wanhe, Wanjiale, etc.
The water flow rate for bathing and washing vegetables is not the same, so the water heater should be adjusted again when bathing. >>>More
It's the water temperature is too high and upside down! Because the water heater itself comes with a safety installation, it will not cause accidents. Otherwise, there will be safety hazards! >>>More
This is because the hot water pipe in your home is relatively long, and after the water heater is started, you must first release the original cold water in the hot water pipe before the hot water can come out, and some people even need to put hot water for ten minutes before it can come out.
Generally speaking, gas water heaters are next to the kitchen, so it is normal for the kitchen to have hot water. The bathroom is a little farther away, and the hot water will pass a little longer. If you can't get hot water for a long time, you should find a professional maintenance person of the property to check it.