-
Anonymous users2024-01-24The water flow rate for bathing and washing vegetables is not the same, so the water heater should be adjusted again when bathing.
It is recommended that you open the mixing valve when taking a bath and do not mix cold water, when you mix cold water, the cold water entering the water heater is reduced, resulting in no fire, or can be ignited, but because the water flow in the water heater is too small, the water temperature in the water heater is too high, over-temperature protection occurs, the water heater stops not heating, so that the water outlet only has cold water, and there is a sudden situation that there is no hot water, then you open the mixing valve to the direction of hot water, and the temperature in the water heater drops below the over-temperature protection temperature, and then starts heating. At this time, the hot water at the outlet is too hot, and there is a sudden hot water phenomenon.
You mix it with cold water and do it again and again.
It is related to water pressure, it is easy to start far away, the plastic film inside the gas water heater is broken, I used to use the Chigo water heater every other year, this phenomenon will appear, I have to call someone to change it once, it costs dozens of yuan, and the cost is less than a dime. . . Caused by high water temperature.
This is because the hot water pipe in your home is relatively long, and after the water heater is started, you must first release the original cold water in the hot water pipe before the hot water can come out, and some people even need to put hot water for ten minutes before it can come out.
Generally speaking, gas water heaters are next to the kitchen, so it is normal for the kitchen to have hot water. The bathroom is a little farther away, and the hot water will pass a little longer. If you can't get hot water for a long time, you should find a professional maintenance person of the property to check it.
It will not be cold, and if you use too much hot water from the faucet, there is a possibility that the heat output will decrease.
First remove the shower, put the water to try, if it is still not normal, and then remove the interface at the outlet pipe of the water heater, check whether there is any blockage, after cleaning, it should work normally.