-
Anonymous users2024-01-24Slight blockage: Sometimes we choose to pour the paper and leftovers into the toilet bowl and use the momentum of the toilet bowl to flush it away at one time. If this is the case, it is advisable to use a toilet unclogging tool.
Dirt: Sometimes when our toilet bowl is used too much, it will produce a lot of dirt, which is difficult to clean, at this time we have to use our toilet bowl cleaner, and pour the cleaner into the water tank.
Soap: Sometimes the soap gets into the toilet after taking a shower, and in this case, we just use hot water to melt the soap.
Toilet Shifter: The toilet is not directly facing the sewer pipe, and if it is not installed properly at the beginning of the installation, it needs to be repaired by a maintenance personnel.
Not enough horsepower: Sometimes we can see that when we press the toilet flush, there is not enough horsepower to do it, so we keep pressing the flush button to increase the horsepower.
There is also a time when you yourself are because the previous person did not flush the toilet after using it, and has been flushing the toilet, at this time, you should pay attention to the fact that the use of the punch will lead to the lack of punch in the next few times, at this time, use a tool to dredge it first, and then press the button after a while.
Aging: After using it for a long time, because of the aging of the toilet, there is a lot of hard dirt in the passage below, which is inconvenient to enter the water and easy to block the water.
-
Anonymous users2024-01-23Add some dish soap and rinse with water.
If there is no water tank, the water pressure is relatively low, which may result in insufficient impulse.
Toilet flushing is generally divided into the following situations: >>>More
That's for sure, it's clear from the analysis of the original process used in the toilet bowl. It turns out that the steps of a housewife in Jiangnan to empty the toilet every morning are: 1. Dump the internal dirt, 2. Scrub it with a brush in the water a few times. Then take it back for backup. >>>More
That's the quality of the toilet. It is that the porcelain light on the surface is not very well done and not smooth enough. There will be such a problem, it should be near those parts every time, and the water in the tank may not be enough or the momentum may not be enough.
The kitchen tile has more oil stains and stubborn, not easy to clean, you can try to pour some white vinegar in the warm water, and then wipe the tile, the effect is more obvious.