How to wire the four open single control switch, living room light, a total of six wires, a yellow w

Find one end of the fire wire switch of the lamp, and the other end of the switch can be tried one by one.

This should be a dual-control wiring board, used for single control, the live wire is connected to any end in the middle, and the other intermediate ends are connected with a jumper, and the control wire of the lamp is connected to the position of the screw at the lower end.

Just connect it according to the circuit diagram provided by the bath bomb; The original line of the bath bomb can be removed, and six wires can be placed from the bath bomb installation position to the switch installation position (if conditions permit, the color of the line can be selected white, green, red, yellow and other two-color lines, and the other two-color line is only used with one, and the other is spare) white, green, red, yellow line one end is connected to the port of the corresponding color of the bath bomb, one other color line L terminal, the other end of the white line is connected to the lighting switch, the green line, the red line is connected to the two heating switches, and the yellow wire is connected to the ventilation switch, On the terminal of the L terminal, there is a wire on the connector; The live wire of the power supply is connected to the L terminal of the bath bomb, and the neutral wire is connected to the N terminal of the bath bomb. If possible, for safety, connect a leakage switch on the power supply.

Give you a line Li Min road map vertical height, refer to the connection of the remaining disturbance ruler surface.

If you borrow money with a small amount of money with five holes in the head of the bed, he should have a three-color wiring method.