-
Anonymous users2024-01-24If the lead screw pitch is 12
Then the hang-wheel ratio is 25/12
Multiply by 2 times. Equal to 50/24
The spindle and spindle output are 1:1
The spindle output shaft is 50 hanging lun.
The number of teeth in the middle and upper wheel is arbitrary, and it can be bitten.
The input shaft of the pass box and the screw rotate at 1:1
That is, the lead screw handle is adjusted to the position of the pitch 12.
The number of hanging wheel teeth on the input shaft of the pass box is 24
Just drive and work.
Spindle? Generally, there is a taper pin fixed, take the taper pin, loose nut, adjust with a dial gauge, adjust the outer circle of the car, about 80 times long, measure the taper with a micrometer, see whether the cone is or the reverse cone, and adjust it by the headstock with the dial gauge.
It won't affect the use, but after too much, it will leak oil all over the ground!
1.Carbon deposits can cause insufficient combustion of gasoline and cause the engine to shake. The impact of engine carbon deposition on the car is quite large, first of all, to reduce the engine power, that is, to make the power output uneven and gradually decay, in other words, more and more powerless. >>>More
Now CA6140 lathes are not the same, each manufacturer is different, you have to make specific drawings for specific analysis.
This is a standard part that can be purchased at a local machine tool repair shop.