What kind of bath bomb is used for integrated ceiling, and what are the precautions for bath bomb in

1. The power wiring should be standardized.

The power of the bath bomb is also relatively high, and it can reach up to more than 1100W.

At the same time, it is necessary to know that the bathroom is a relatively humid place, to choose a waterproof line, it is best to choose a multi-wire copper core wire of not less than 1mm, and all power wiring should be embedded in the wall with a plastic hidden pipe, so that it is relatively safe to use, and its switch is also to choose a qualified product with a waterproof capacity of more than 10A, so as to ensure its safety performance.

2. It should be installed in the center of the bathroom.

Many families will consider installing a bath bomb above the shower or bathtub position, which has many safety hazards on the surface. You must know that this kind of electrical product relies on infrared radiation lamps to heat up quickly, and if it is installed too close, it will burn the human body. Therefore, the correct installation method is to install it in the center of the top of the bathroom or slightly close to the bathtub, so that it is the most reasonable position.

3. Do not spray with water when working.

We also need to pay attention when using, we know that although the bath bomb is waterproof now, we must know that it cannot be splashed with water, or it is not easy to cause the danger of short circuit in the power supply.

4. Keep the bathroom clean and dry.

After the bath is completed, it is recommended that you do not turn off the bath bomb immediately, it is best to turn it off after the moisture in the bathroom is discharged, and at the same time keep the room ventilated, clean and dry, only in this way can the service life of the bath bomb be extended.

Note 1: 62616964757a686964616fe58685e5aeb931333433636236: Install from the edge.

When the integrated ceiling bath bomb is installed, it is first necessary to start the installation from the corner line, and the general integrated ceiling time is after the tiles on the home have been installed, so as to ensure that the installation of the integrated ceiling is kept on the same level as the corner line, so that after the installation of the integrated ceiling, it looks like there will be no obvious gaps.

Note 2: Material selection.

When selecting materials, I believe that we have almost understood some of the characteristics of the material, here to add some questions about the details, the installation of integrated ceilings must use light steel keels and booms, the keel between the poly mastery is very important, but when we are customized, the size must be consistent, and there must be no small situation.

Note 3: Install the gusset.

The installation of the gusset will affect the decoration effect of the whole room, the flatness of the installation of the gusset is a big problem to be controlled, the flatness will affect the aesthetics of the overall integrated ceiling, and the generation of gaps can be reduced as much as possible, even if there are gaps, it can not be too big, if the gaps are too large, after the follow-up project is completed, it is necessary to do caulking, and the gaps must be straight, and the installation of bath bombs can appropriately reduce a lot of gaps.

Note 4: Wire installation.

Don't forget, bath bomb is also a very high-power household appliance, the general power is more than 1100w, so when installing the bath bomb, it is necessary to strictly take this into account, and the environment of the bathroom is relatively humid, so the installation safety is very important.