Problems with plasterboard ceilings

It is better not to use plaster ceilings.

On the one hand, gyplight is heavier, and large areas of gypsum board are easy to fall off.

On the other hand, gypsum board ceilings can also crack, and a layer of cloth must be pasted on the edge joints to prevent cracking.

The integrated ceiling is beautiful, but the cost is relatively high.

Personally, I recommend using an integrated ceiling.

FYI!

Seems to be the case.

The steel structure compartment, after all, is steel, and sometimes it will be load-bearing, and the steel frame we generally know that if it is load-bearing, it will be deformed, and then the gypsum board below will also be stretched, and it will crack. The most prone to cracks are the outer edges of the plasterboard under the steel structure.

It is a bit difficult on the surface of the suspended ceiling under the steel roof, but it is not too difficult in fact, and there are many ways to choose methods and materials. Considering that the roof vibration ceiling can be just connected to the static wall as long as it is not connected, it is recommended to do modeling ceilings, aluminum plates, and aluminum hanging sheets.

1. All this is when doing the ceiling, the nail is not brushed with anti-rust paint, or the anti-rust paint is unqualified, and the remedy is not very easy to do, first scrape the putty at the nail place, brush a layer with anti-rust paint at the place of the nail, the area is slightly larger, and then dry and batch putty again, and then brush the latex paint. If this is not possible, it can only be dismantled. The foundation hasn't been laid.

It stands to reason that where there are nails, they should be closed with special edge banding. Buy some edge banding and stick it up. Scrape it again and you'll be fine. A roll of 50 meters is about 20 yuan.