Problems with steel frame compartments and gypsum board ceilings

Updated on Suspended ceilings 2024-05-16
3 answers
  1. Anonymous users2024-01-24

    If it is a tooling that requires specifications, it is necessary to weld the screw rod on the steel frame, then install the light steel keel, and finally put on the gypsum board;

    If it is a home improvement with low requirements, you can fix the wooden keel directly with dovetail screws on the steel frame, and then put on the gypsum board.

  2. Anonymous users2024-01-23

    The gypsum board ceiling has a keel (T-shaped aluminum strip and the like), you can hang the keel on the steel frame with iron wire, and a few steel angles can be welded where there is no steel frame, and the span is large to make a triangular beam.

  3. Anonymous users2024-01-22

    If the hoisting position is higher from the roof, the iron plate needs to be embedded, and the floor slab needs to be drilled through and fixed with a screw, and then the hoisting parts can be welded.

Related questions
1 answers2024-05-16

Clause.

First, the material of the light steel keel gypsum board ceiling construction process. >>>More

1 answers2024-05-16

The quality of drywall refers to the strength and flexibility. What determines the material (the amount of fiber in the gypsum material) plays a decisive role. If the quality is better, the strength is good, the toughness is not easy to break. The flatness of the ceiling is good and not easy to deform!

4 answers2024-05-16

With a weight of less than 5kg, you can fix it directly to the plasterboard with professional fastening nails. >>>More

7 answers2024-05-16

The installation of decorative gypsum board ceiling can be set up according to the material conditions of various places, such as shelving and flattening, screw fixing and adhesive bonding. (1) Shelving flat method: when using T-shaped aluminum alloy keel or light steel keel, the decorative gypsum board can be shelved in each grid frame composed of T-shaped keel, that is, to complete the ceiling construction. >>>More

2 answers2024-05-16

If you do that, the top will not be flat.

First of all, the bottom surface of the I-beam of the compartment itself will not be flat, and the weight pressed on it will cause it to be high and low. Also, when installing the I-beam, its perimeter is not necessarily horizontal. >>>More