Can I use plugging agent for bathroom floor tile joints? I don t want to use a grout

The answer is yes. If the floor tiles in your own bathroom (including the kitchen) do not deliberately pursue the beautification of the gaps and pay attention to practical results, choosing a plugging agent is the best choice.

Construction method: Buy a (according to the price, quality can choose) plugging agent (commonly known as "water does not leak", "plugging spirit"), and "caulking strip" (available in decoration stores, a paper strip about three centimeters wide).

Steps: First, wipe and dry the surface of the tile, especially the edge of the gap of each brick;

Second, paste the paper strip on both sides of the gap, and only expose the tile joints in the middle, so as to avoid irregular lines after construction;

3. Pour a small amount of plugging agent into a small container (note, do not pour too much, because the plugging spirit belongs to the quick-setting type, too much can not be used and will cause waste), and adjust the water into a thin paste;

Fourth, use a small brush to dip the paste along the gap and paint it, remember: do not paint outside the paper strips on both sides;

Fifth, after the whole is completed, slowly tear off the adhesive strip.

Generally, when the floor tiles are just paved, the adhesive layer of the floor tiles will contain a certain amount of moisture, and it is also possible to hook the joints with dry powder. However, there will be a problem, that is, the density of dry powder is not as good as that of adding water and stirring.