How to install fixed furniture to be firm

Design and installation method of fixed furniture:

1. Furniture materials are in place, first check whether the size of the fixed furniture materials meets the needs of the site, similar to this fixed wood veneer in order to facilitate factory production, the method of appropriate lengthening on the side of the wall is generally adopted, and it is also a way to reduce the order error of fixed design.

2. Cutting of fixed furniture materials: open the size of the air conditioning outlet according to the on-site situation, and the size of the air conditioner is 700*170. The air conditioning vents of each hotel are different and cannot be generalized.

Cutting the protruding position of the wall, according to the actual size, not too large or too small, Lu Junlin has nothing to say. Measure whether the height of the left and right sides is consistent, to prevent the ceiling or ceiling tilting, if there is a large difference between 1 and 2 heights, more than 5mm, it is necessary to cut the beveled edge of the furniture material to ensure the perfection of furniture installation.

3. Treatment of the on-site base layer: In this case, due to the lack of work of the decoration construction party to lay the base layer, it will bring great disadvantages to the installation of fixed wood veneer. The site is used to fix the wood veneer by adding small wooden strips according to local conditions (in the future, F30 nails are directly used on the wood veneer, which can be blocked by the air conditioning louver frame in the later stage).

4. After the above three steps of preliminary work, the official work begins: first put the fixed wood veneer on the site and compare it again to confirm that there is no error in the size. First coated with glass glue (it is best to use nail-free glue, this glue is currently not popularized and the popularity rate is not high, and the more sensible installers have been using this method, but I am too lazy to pay attention to this matter in this factory, the reason for many things is not convenient to say, the reason you know); Apply foam glue again; Fix it with F30 nails along the edge of the tuyere (the position of adding a small wooden strip in front); The wood veneer interface process is nailed and reinforced in the seam to prevent the edge from being warped.

Pay attention to the flatness of the left and right wood veneers; Finally, add a small wooden strip at the end of the wall for temporary fixation, to prevent the expansion of the foam glue to cause the deformation of the wood veneer (the installer is lazy to save it), so far the installation of the fixed wood veneer is over.

The foundation of the firmness of the furniture is the structure of the furniture itself, the articulation process of the frame, and the rigidity of the material. The previous elements have been reached, and the later stage is only required to be installed normally.

Fixed-mounted home is fixed on the wall of furniture or wall panels, installation or to ask professionals to implement, otherwise the installation will be dangerous, if it is a carpentry production needs to be installed by the construction team, if it is a home factory to do, ask their professionals to install, this is generally not money. Yu Shang Meijia replied.

Use an electric turn to hit the eye and the wall, use a wooden needle and the eye, and staple the inner or inconspicuous part of the furniture and the wooden needle with a steel nail.

Solid furniture knowledge a general term, a lot, each installation method is different, if you have any questions, you can contact me, I fixed furniture designer,