-
This is obviously a problem with your outlet.
The night light can be plugged in to indicate that the voltage has been sent to the conductor of the outlet.
If there is no response when plugging in a lot of electrical appliances, there are two possibilities:
1. The conductor reed in the socket is not standard or deformed, resulting in the conductor of the electrical plug and the reed of the socket cannot be contacted, and the voltage cannot be sent to the electrical appliance. This is mostly manifested in inferior outlets.
Open the socket and clamp the reed with needle-nose pliers for correction, or update the high-quality socket to troubleshoot.
2. There is a poor contact in the socket. Although the night light can be lit, after all, the current is very small, and the voltage drop at the contact point is not very large. When using other electrical appliances, due to the large current, most of the voltage falls at the wire end of the poor contact, and the voltage left for the electrical appliance is not enough to work with the electrical appliance.
This often happens in outlets that have a history of short-circuit failures.
The solution is to disassemble the socket and carefully check each terminal point, whether there are loose screws, serious rust or discolored wires (the wiring row socket should also be specially checked for conductor breakage at the root of the tail line into the socket strip), and the suspicious points should be reconnected according to the process.
-
In this case, it first depends on whether your night light is LED or incandescent, if it is LED. That could indicate that there is a leak in your outlet line. Because the turning voltage of the LED is relatively small, it can be turned on by more than ten volts.
But the power of the appliance must be 220, so it can't work.
-
Hello, this is normal. It means that the voltage there is low and unstable. If you want to change, you can turn off the electrical equipment that consumes a lot of electricity at night, maybe you can use it.
-
What home socket can be used night light, electrical appliances will not be powered, in this case, it may be a problem of voltage, the voltage used in small spotlights is relatively low, then household appliances are normal, 220 volt voltage, when the voltage can not be reached, household appliances can not be used.
-
This situation shows that the voltage of your home is not very stable, and the voltage is low, the voltage of the night light does not need to be very high, the power of the electrical appliances at home is large, the voltage requirements are relatively high, and it must reach 220 volts to be used normally.
-
If there is no electricity for electrical appliances, and there is electricity for night lights, it means that the voltage is insufficient, and when the voltage is insufficient, it is impossible to supply high-power electrical appliances.
-
It should be a fault of the line, or the contact point is not in good contact, resulting in insufficient voltage, so check it carefully.
-
It's just that there is no electricity, and the voltage is not enough. Ask other homes if there is electricity, and if there is none, find an electrician to find the reason.
-
Because of course it's good to do that.
-
It's the reason why the power can't be reached! It is recommended to find an electrician to repair it.
-
There is a switch for mosquito coil liquid, do you press it?。。
I'm going to see it. Some USB night lights are live broadcast 220V, so they can't be plugged directly into the power bank. >>>More
The key is to see if their operating voltages match. The working voltage of the 600w hair dryer is 220V, right?
It may be that it has been a long time, and the LED light is not always hot, the LED light is its lamp will not be hot, but the circuit board will be hot, this is an electrical appliance, in which the circuit board is a resistor, the time is long, the current continues to pass through the heat generated.
Hello, the wire inside the kitchen socket is wrong.
As long as the load on the wires is sufficient, it doesn't matter. You can share a line.